Description of the SMS center setup for the Panasonic KX-FC 248CE

4.14 Instruction for setting SMS service

• When determining the position of the keys, have the front cover open.

1. Press the button (in the middle of the navigation button)
2. Select and then press OK
3. Select " Parameters" and then press the button OK.

4. Enter the code "0000" (default base PIN)

   • if you changed the code, enter the new one (page 82)
5. Select " SMS ON/OFF" and then press the button OK.
6. Select " ON" or " OFF" and then press the button OK
7. Press the button "[X0]"

NOTE:

• if you try to send a message when the SMS service is switched off, you will hear a tone and the message will be saved in the received messages folder, marked with "FD".
• if someone sends you a message when the SMS service is switched off, the message will not be received and the number of the message centre will be recorded in the ID list of incoming calls.

In this device you have the following numbers pre-programmed (for provider Èeský Telecom). If you wish you may change these numbers. - message centre 1:1470

• Your provider will have more information available for you.

1. Press the button (in the middle of the navigation button)
2. Select ... and then press the button OK
3. Select "Parameters" and then press the button OK.

4. Enter the code "0000" (default base PIN)

   • if you changed the code, enter the new one (page 82)
5. Select " Message centre 1" or " Message centre 2" and then press OK
6. Check if the entered number is correct and make changes if necessary and then press OK twice.
7. Press the button "[X0]"

• If your telephone is connected to the PBX switchboard, you must enter, besides the number of the message centre 1, also the access number of the PBX line, plus space. Save the number of the message centre 1 for the message centre 2 in unchanged form without the access line number or space.