Description of the SMS message setup
You can also direct your queries about the SMS number setup
to Micos, spol. s. r. o. at 532 192 511.
Activation and deactivation of the SMS
service.
The default setting is "On".
- Press
OK
- Select "SMS" and then press
>
- Select "Settings" and then press
>
-
Enter the code "0000" (default base PIN)
- if you changed the code, enter the new one (page
32)
- Select "SMS ON/OFF" and then press
>
- Select "ON" or "OFF" and then press
>
- Press [X0]
|
- Your provider will have more information available
for you.
- Press
OK
- Select "SMS" and then press
>
- Select "Settings" and then press
>
-
Enter the code "0000" (default base PIN)
- if you changed the code, enter the new one (page
32)
- Select "Message centre 1" or "Message centre 2" and
then press
>
- Check if the entered number is correct and make
changes if necessary and then press OK twice.
- Select "Save" and then press
>
- Press "[X0]"
|
SMS service centre number change
In order to receive and send SMS messages you must save
numbers of the SMS service centre.
For the Czech Republic:
In this device you have the following numbers
pre-programmed (for provider Èeský Telecom). If you wish
you may change these numbers
For the Slovak Republic:
In this device you have the following numbers
pre-programmed (for provider Èeský Telecom). If you wish
to use the SMS service, save numbers of Slovenský Telecom
in your device.
|
Note:
- If your telephone is connected to the PBX switch
board, you must enter, besides the number of the
message centre 1, also the access number of the PBX
line, plus space. Save the number of the message centre
1 for the message centre 2 in unchanged form without
the access line number or space.
|
